Siemens SINUMERIK 840D sl Operation/Programming Manual page 255

08/2005
5
Full circle Position slots around a full circle. The slot spacing is uniform and is calculated by
the control.
Pitch circle Position slots around a pitch circle. The slot spacing can be determined on the basis
of angle α2.
End face/End face C:
The reference point is always the center point of the full or pitch circle.
X0 Reference point in X direction (abs.)
Y0 Reference point in Y direction (abs.)
L0 Reference point on longitudinal polar axis (alternative to X0)
C0 Reference point on angular polar axis (alternative to Y0)
Z0 Reference point in Z direction (abs.)
Z1 Slot depth based on Z0 (abs or inc) – (only for roughing and finishing)
DZ Maximum depth infeed (Z direction) – (for roughing and finishing only)
UXY Finishing allowance in the plane (slot edge) – (for roughing and finishing only)
FS Chamfer width (abs) – (for chamfer only)
ZFS Insertion depth for the drill tip (abs or inc) -- (only for chamfer)
Peripheral surface/Peripheral surface C:
The reference point is always the center point of the full or pitch circle.
Y0 Reference point in Y direction (abs.)
C0 Reference point on angular polar axis (alternative to Y0)
Z0 Reference point in Z direction (abs.)
Cylinder diameter ¬ (abs.)
X0
Slot depth based on X0 ¬ (abs or inc) – (only for roughing and finishing)
X1
DX
Maximum depth infeed (X direction) – (for roughing and finishing only)
UYZ
Finishing allowance in the plane (slot edge) – (for roughing and finishing only)
FS
Chamfer width (abs) -- (for chamfer only)
ZFS
Insertion depth of tool tip (abs or inc) -- (for chamfer only)
End face Y:
The reference point is always the center point of the full or pitch circle.
CP Positioning angle for machining area
X0 Reference point in X direction (abs.)
Y0 Reference point in Y direction (abs.)
L0 Reference point on longitudinal polar axis (alternative to X0)
C0 Reference point on angular polar axis (alternative to Y0)
Z0 Reference point in Z direction (abs.)
Z1 Slot depth based on Z0 (abs or inc) – (only for roughing and finishing)
DZ Maximum depth infeed (Z direction) – (for roughing and finishing only)
UXY Finishing allowance in the plane (slot edge) – (for roughing and finishing only)
FS Chamfer width (abs) -- (for chamfer only)
ZFS Insertion depth of tool tip (abs or inc) -- (for chamfer only)
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
ShopTurn Functions
5
5.5 Milling
mm
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
5-255