Remove Temperature Sensor - Maytag 30 Series Service Manual

reMOve TeMPeraTure SenSOr

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the rear panel (See page 4-28).
Temperature
Sensor
4. Press the locking tab and remove the wire
connector from the sensor.
5. Pull the temperature sensor out of the tub
with a slight twisting motion.
Temperature
Sensor
6. Remove and replace the grommet only if
necessary.
n It is easier to reinstall the grommet when
separated from the sensor first.
It may help to wet the temperature sensor
n
when reinstalling it since it is a tight fit in the
rubber grommet.
Rubber
Grommet
4-30