Control Set-Up Procedures - Maytag 30 Series Service Manual

iMPOrTanT: Read all instructions before
operating.
PD Models: Use service key to remove
n
service access door. Lifting the service
access door engages the service switch.
n PR Models: Once a Generation - 2 debit
card reader is installed (according to the
reader manufacturer's instructions), the
set-up codes can be changed by inserting
a manual set-up card (supplied by the
reader manufacturer) into the card slot or
by the use of a handheld device with DA
communication and AccuTrac software. If a
manual set-up card or a handheld AccuTrac
device is not available, only diagnostic
mode can be entered by removing the
connector AA1 on the circuit board.
PR Models set up as PNs :
n
Service Access Code: This code can be
entered to access service mode without
removing the console. It only functions on
washers set up for 0 vend price without any
Special Pricing set-up, and the Coin/Debit
Option must be set to "J._d". If the washer
is not in failure mode, the door must be
opened to proceed. Service Access Code
contains 6 steps and some are timed. Using
only the three bottom buttons (numbered 1,
2, and 3 from left to right):

COnTrOL SeT-uP PrOCeDureS

1. Press 2 for longer than 2 seconds but less
than 10 seconds.
2. Press 1 & 3 together for 2 seconds, then
release. Displays S 3.
3. Press 1 & 2 together, then release.
Displays S 4.
4. Press 2 & 3 together, then release.
Displays S 5.
5. Press 2, then release.
Displays "codE".
6. Wait at least 2 seconds, but not more than
15 seconds, then press in succession:
3, 2, 1, 3.
nOTe: If the Service Access Code procedure
is not completed properly, as noted above,
there is a 15 second delay before it can be
attempted again.
n There are 3 options to exit from the Service
Mode when the Service Access code has
been used to enter it:
1. From Set-up Code 8, press PERM. PRESS
for 4 seconds.
2. Wait 2 minutes without touching any buttons
(without diagnostic modes running).
3. Power down the washer, then reapply
power.
3-4