Remove Door Hook; Remove Door And Hinge Assembly - Maytag 30 Series Service Manual

reMOve DOOr HOOk

1. Open the washer door.
2. Remove two T-20 screws that secure the
hook to the door.
Two T-20
Screws
3. Depress the locking tab and rotate the hook
down and out of the slots in the door.
Locking Tab
reaSSeMBLY nOTe: When reinstalling
the door hook, do not tighten the hook
completely. The hook should remain loose
enough to move as it needs to center itself
when the door closes. The screws have
shoulders to help keep the hook from
becoming too tight. Make sure these screws
are used when reinstalling or replacing the
door hook.
reMOve DOOr anD HinGe
1. Open the washer door.
2. Remove two 1/4" hex head screws that
secure the hinge to the front panel.
Locking Tab
3. Lift the door and hinge assembly up and pull
the hooks out of the slots in the front panel.
n This model front loading washer has a door
hinge which allows the door to open a full
180 degrees and a slanted inner bowl glass
which helps move the clothes to the back of
the washer (shown in top picture above).
4-18
aSSeMBLY
Two 1/4"
Hex Head
Screws