Flashing Mode; Special Cycle Mode - Maytag 30 Series Service Manual

For PR Models:
n Remove the AA1 connector from the UI
board or insert a manual diagnostic card.
n Enter the Service Access Code
(See page 3-4) for PR washer models set-
up as PN without a key switch installed.
Insert key and turn, if diagnostic key switch
n
is installed on PR models set-up as PN
washers.
n The current F code or d code will be
displayed.
If the washer is showing an error code,
n
consult "FAILURE/ERROR DISPLAY
CODES", (See page 6-2). Displayed error
codes that are not listed in this manual
are most likely caused by a card reader
device. Please contact the card reader
manufacturer for explanation of these
codes.
b) Functions of the Code Display Mode:
n Display of the current failure code.
n To erase the current error code and access
Flashing Mode, press QUICK CYCLE
button for 2 seconds.
n To access Set-up Mode, without erasing
the current error, press DELICATES AND
KNITS button for 1 second.

FLaSHinG MODe

This mode allows starting of special diagnostic
cycles, running of a Quick Drain and Spin,
crediting of free cycles, and access to the
Washer Cleanout Cycle.
a) Accessing the Flashing Mode:
For PD Models:
Open the service door.
n
Press QUICK CYCLE button for 1 second.
n
For PR Models:
n Remove the AA1 connector or insert a
manual diagnostic card.
n For PR washers set up as PN washers, the
Service Access Code may be used.
n Insert key and turn, if diagnostic key
switch is installed on models set-up as PN
washers.
n When dAS is displayed, press QUICK
CYCLE button for 1 second.
When accessing the flashing mode, the
display will be blinking, turning all the
segments on and off. Any cycle in process
is cancelled, any money in customer escrow
is cleared, and existing diagnostic codes are
cleared.
b) Functions of the Flashing Mode:
n To access the Quick Overview Test, press
the DELICATES AND KNITS button
(See page 6-8).
To access the Manual Overview Test, press
n
the WHITES button (See page 6-9).
n To run a Quick Drain and Spin, press the
COLORS button.
n To access the Washer Cleanout Cycle,
press the BRIGHTS button.
To Credit a Free Cycle, press the PERM.
n
PRESS button.
n To Exit the Flashing Mode and return to Set-
up Mode, press the QUICK CYCLE button.

SPeCiaL CYCLe MODe

This describes the diagnostic cycles accessed
through the Flashing Mode.
6-7