6.7.8. Software version (SV)
Note
Shows the version of the software used by the controller.
G
Software version display:
6.8.
Resetting the controller
Note
There are two methods to reset.
6.8.1. Soft reset (SR)
Caution
All the parameters are set to default values, except volume remaining in volumetric
systems and days since last regeneration in time clock systems.
A
Press and hold
until SR is displayed.
B
Reprogram all parameters in Master programming mode.
6.8.2. Hard reset (HR)
Caution
All the parameters are set to default values.
A
Hold
while powering up the unit.
B
The display shows HR.
C
Reprogram all parameters in Master programming mode.
Ref. MKT-IM-016 / C - 08.06.2018
and
for 25 seconds while in normal service mode
Installer Manual Fleck 5810 - SXT - Programming
73 / 106