6.7.
Diagnostic
Note
Depending on current settings, some displays cannot be viewed.
Note
If none of the buttons are pushed for 1 minute in the diagnostic mode the controller returns
to Service mode.
6.7.1. Commands
A
Press and hold
B
Press
or
C
Press
to exit the Diagnostic mode at any time.
6.7.2. Current flow rate (FR)
Note
The display is updated every second.
A
Current flow rate display (L/min or gpm depending on display format
programmed):
6.7.3. Peak flow rate (PF)
Note
The controller registers the highest flow rate since the last regeneration.
B
Peak flow rate display (L/min or gpm depending on display format
programmed):
Ref. MKT-IM-016 / C - 08.06.2018
and
for five seconds to enter the diagnostic mode.
to navigate in the diagnostic mode.
Installer Manual Fleck 5810 - SXT - Programming
71 / 106