Mira COMBIFLOW User Manual page 37

1.2 For standard inlets turn the square lever locator fully anticlockwise and clockwise
for reversed inlet.
Fit the maximum temperature stop assembly into the two slots either side of the
square lever locator on the shower control (Note! Make sure that the maximum
temperature stop assembly has the red side facing towards you. One slot is
wider than the other to make sure of correct installation, see illustration below).
Push the maximum temperature stop fully on.
Square Lever Locator
Wider Slot
1.3 Fit control lever onto square lever locator (see fitting control lever).
Lift lever towards you to turn the shower on to give a typical shower force.
Turn lever clockwise to increase temperature until movement stops and allow
temperature to stabilise. If this maximum temperature is satisfactory, then firmly
tighten grub screw and fit grub screw cover. If the temperature is not satisfactory
refer to 9.4.
(Note! For reversed inlets a reversed inlet control lever is required.
Anticlockwise movement will increase temperature. If the maximum
temperature is not satisfactory then the maximum temperature stop will
require adjustment.
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk
Front View standard inlet
37
Red Upstands