Mira COMBIFLOW User Manual page 25

To make sure that the shroud fully
locates over the body of the
Combiflow B, the tabs on the building-
in shroud MUST be bent inwards where
the shroud meets the mounting
brackets (refer to illustration).
Note! If using the fixing holes on the
body casting to fix to the back wall or
wooden noggin, the mounting brackets
are not required and therefore you do
not need to bend back the tabs.
Failure to carry out this procedure will
result in the 'min' to 'max' building in
depth shown on the shroud being
incorrect.
3.12 Temporarily fit the building-in shroud.
Check that the valve is level. Align the
holes in the support bracket with the
holes in the wall and secure the unit
with the two fixing screws (supplied).
Remove the building-in shroud to allow
access to pipe connections.
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk
Fixing Screw
25
Support Bracket
Adjustment
Alternative Rear
Fixing