Mira COMBIFLOW User Manual page 24

3.7 Mark the route of the inlet and outlet
pipes.
3.8 Remove the plaster and brick/block for
the shower control to a depth between
47 and 70 mm from the finished
surface of the wall, with a finished wall
surface thickness between 6 and
23 mm.
3.9 Remove the plaster and brick/block for
the inlet and outlet pipes.
3.10 Mark the support bracket fixing hole
positions.
Note! Support brackets can be
adjusted to find a secure fixing and
ensure easier spanner access to
compression connections. The
support bracket
positioned so that the valve can be
fitted level and the compression
fittings can be easily tightened.
3.11 Drill a 6 mm diameter hole at each of
the marked positions and insert the wall
plugs (supplied).
Note! For stud partition installations
alternative fixings may be required.
Alternatively the support brackets can
be removed and the two mounting
holes in the body can be used to fit to
the wall cavity or to a timber nogging.
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk
Finished Wall
Surface
Finished Wall
Surface
23 mm
Maximum Depth
should be
24
6 mm Minimum Depth
Alternative
support
fixing
Support
Bracket
47 mm
Support Bracket
Adjustment
Fixing Holes