Connections For A Cut Editing System - Sony DVCAM DSR-60P Operating Instructions Manual

Connections for a Cut Editing System

The following figure shows a cut editing system
configuration that uses this unit as the player and a
DSR-85/85P as the recorder.
When you select assemble or insert editing
mode on the editing controller, the EDIT
MODE indicator lights on the front panel of the
recorder and the recorder automatically enters
the selected editing mode.
DSR-60/60P
(player)
ANALOG I/O
REF.VIDEO VIDEO OUT
COMPONENT VIDEO
TIME CODE OUT
AC IN
MONITOR S VIDEO OUT
AUDIO
MONITOR
AUDIO
3
Audio input
Source monitor
a) For the settings on the editing control unit,
see "Settings on an editing control unit"
(page 47).
Settings on the DSR-85/85P (recorder) and
DSR-60/60P (player)
Switch
REMOTE/LOCAL
For details of the video/audio input and audio mode settings
for the recorder, refer to the DSR-85/85P Operating
Instructions.
Note
When the recorder and the player are interconnected
via the QSDI interface, jog audio monitoring is not
possible with the recorder and its monitor even if the
recorder is in EE mode. For this purpose use the
player and its monitor.
42
Chapter 5 Connections and Settings
QSDI OUTPUT
QSDI QSDI SDI OUTPUT
AUDIO OUT
TBC REMOTE REMOTE
VIDEO REMOTE
OUT 2
(SUPER)
1
Composite
2
video input
PLAYER
Editing control unit (such as
RM-450/450CE, PVE-500, etc.)
Recorder Player
REMOTE REMOTE
For details of connecting devices other than the DSR-60/
60Ps, refer to the instruction manual for each device.
1 75 Ω coaxial cable (not supplied)
2 9-pin remote control cable (one cable
is supplied with the DSR-60P)
3 Cable with RCA phono plugs
(not supplied)
1
REF.
VIDEO
OUT
MONITOR
AUDIO
3
1
Audio input
REF.
VIDEO IN
Main monitor
RECORDER
a)
About reference video signals
In order to provide stable video and audio signals for
analog editing, it is necessary for the built-in time base
corrector (TBC) to operate correctly. To ensure this,
input a reference video signal synchronized with the
video signal to the REF. VIDEO IN connector and set
the REF. VIDEO IN 75 Ω termination switch to ON.
DSR-85/85P
QSDI
(recorder)
INPUT
VIDEO
REMOTE
OUT 2
(SUPER)
1 2
Composite
video input