Sony DVCAM DSR-60P Operating Instructions Manual page 25

9
Press the [B]÷ button.
The "A PRESET MODE" screen appears. The time code value of the
current point A is displayed below the screen title.
A PRESET MODE
A 00:18:35:14
UP : DATA INCREMENT
DOWN : DATA DECREMENT
LEFT : LEFT SHIFT
RIGHT : RIGHT SHIFT
RESET : DATA CLEAR
SET : DATA SET
MENU : RETURN TO MENU
Monitor screen
10
Use the ¿[A] or [B]÷ button to select the digit in the time code
value display that you want to change.
Each press of the button causes the digit to the left or right to begin
flashing. Holding the button down moves the flashing digit
continuously. If you want to clear the time code value, press the
RESET (NO) button. The value is cleared to 00:00:00:00, and the
leftmost digit begins flashing.
11
Press the ˘ or ≥ button to increment or decrement the value of the
flashing digit.
Each press of the button increments or decrements the value. Holding
the button down increments or decrements the value continuously. To
change other digits, return to step 10.
12
Press the SET (YES) [MARK] button to confirm the defined value.
The message "NOW SAVING..." is displayed on the monitor screen
and "Saving..." is shown on the time counter display while the new
setting is being saved in the unit's memory.
Caution
The new setting may be lost if you power off the unit during the saving
operation. Wait until the saving operation is completed before
powering off the unit.
If you want to discard the changed value
Press the MENU button instead of pressing the SET (YES) [MARK]
button. This causes the unit to exit from the menu control mode
without saving the changed value into memory.
After the saving operation is completed, the monitor screen and time
counter display return to the REPEAT FUNCTION setting display as
shown in step 8.
(Continued)
25
Chapter 2 Playback