Displaying Enhanced Items; Changing Settings Of Enhanced Items - Sony DVCAM DSR-60P Operating Instructions Manual

Cautions
• The new settings may be lost if you power off the
unit while the above saving operation is in
progress. Wait until the saving operation is
completed before powering off the unit.
• If you press the MENU button without first
pressing the SET (YES) [MARK] button, the new
settings will not be saved. In such cases, the
message "ABORT!" will be shown on the
monitor screen and time counter display, and the
unit will exit menu control mode. When
changing settings for several menu items, be sure
to press the SET (YES) [MARK] button once you
have made all of your settings.
Meaning of the indications in menu display
Meaning
Indication
÷ on the right edge of Pressing the [B] ÷ button brings
the screen (See step 1 you to a lower level menu display.
on page 37.)
¿ on the left edge of Pressing the ¿ [A] button brings
the screen (See step 4 you back to the previous menu
on page 38.) display.
Characters to the right
The current setting for that item
of the name of a menu
When colon (:) is attached: The
item (See step 4 on
page 38.)
When bullet (•) is attached: The
Asterisk displayed An asterisk is displayed in front of
with all of the settings the factory default setting.
under the selected
item (See step 6 on
page 38.)

Displaying Enhanced Items

The factory default setting disallows the display of the
enhanced items.
To display the enhanced items, follow the procedure in
the previous section "Changing Settings of Basic
Items" to set "NENU GRADE" to "ENHANCED".
(Select "MENU GRADE" in step 3 and select
"ENHANCED", then press the SET (YES) [MARK]
button to save the setting in memory.)
Once "MENU GRADE" is set to "ENHANCED", the
level-1 display of both the basic and enhanced menu
items appears when the MENU button and [B] ÷
button are pressed to access the setup menu.
current setting is the factory
default setting.
current setting is not the factory
default setting (See step 2 on
this page).
Changing Settings of Enhanced
Items
Perform the procedure in "Displaying Enhanced
Items" and then the following procedure.
1
SYNC PHASE SC PHASE MENU
MONITOR SELECT
CH- CH- CH- CH-
1/2 3/4 1/3 2/4
MIX
1
Press the MENU button on the menu control panel.
The menu selection level display appears.
2
Press the [B]÷ button.
The level-1 display of the setup menu appears on
the monitor screen.
Level-1 menu display
SETUP MENU
REPEAT FUNCTION
OPERATIONAL FUNCTION
DISPLAY CONTROL
a)
TIME CODE
TAPE PROTECTION
VIDEO CONTROL
AUDIO CONTROL
MENU GRADE •ENHAN
Monitor screen
3
Follow the same procedure as in steps 3 to 8 of the
procedure in the section "Changing Settings of
Basic Items", using the arrow buttons to select an
item and change its setting.
2
RESET(NO)
A B
SET(YES)
MARK
3 4
Menu grade
Time counter display
Current setting
a) DSR-60 only.
(Continued)
39
Chapter 4 Menu Settings