Displaying Supplementary Status Information - Sony DVCAM DSR-60P Operating Instructions Manual

Displaying Time Data and Other Text Information
C DSR-60/60P operation modes
Indication Operation mode
Tape is being threaded (this indicator
THREADING
is displayed from the time a cassette is
inserted until the tape has been
threaded)
UNTHREADING Tape is being unthreaded (this
indicator is displayed from the time the
EJECT button is pressed until the
cassette is actually ejected)
CASSETTE OUT No cassette has been loaded
STANDBY OFF Standby off mode
T. RELEASE Tension release mode
STOP Stop mode
F. FWD Fast forward mode
REW Rewind mode
PREROLL Preroll mode
PLAY Playback mode (servo unlocked)
PLAY LOCK Playback mode (servo locked)
PLAY PAUSE Playback pause mode
JOG STILL Still picture playback in jog mode
JOG FWD Jog forward
JOG REV Jog reverse
SHUTTLE +2.0 Shuttle mode (playback speed)
PAUSE Shuttle playback pause mode
a) "+2.0" in the left box is an example of playback speed
indication.
To display the desired time data in the
time counter display
Press the COUNTER SELECT button on the front
panel of the unit.
Each press of this button cycles through three options:
CNT value, time code, and user bit data. The time
data type indicator for each option lights as it is
selected.
28
Chapter 3 Convenient Functions for Editing Operation
a)
COUNTER SELECT button
Time data type indicators
6 0 ) p
Time counter display
Time data type Time data shown in the time counter
indicator display
COUNTER CNT (count value of the time counter)
TC Time code read from the tape
U-BIT User bit data read from the tape
Note
The COUNTER SELECT button will not operate
while the tape is running when the REMOTE/LOCAL
switch has been set to REMOTE. In such cases, use
the external equipment connected to the REMOTE
connector on the rear panel to select the time data.
To reset the CNT value
Press the RESET (NO) button on the menu control
panel. This resets the CNT value to 0:00:00:00.
Displaying Supplementary
Status Information
When "SUB STATUS" under the DISPLAY
CONTROL menu item is set to "PB FORMAT", the
recording format which was used for the tape being
played back can be displayed as supplementary status
information on the monitor screen below the operating
mode display area.
T C R 0 0 : 0 4
P L A Y
D V
Supplementary status information
The on-screen indications of supplementary status
information and their meaning are as follows.
On-screen Meaning
indication
DVCAM DVCAM format
DV DV format (SP mode)
DV(LP) DV format (LP mode)
. 4 7 : 0 7
L O C K
C A M