Repeat Playback-Automatic Cyclical Playback Between Selected Two Points - Sony DVCAM DSR-60P Operating Instructions Manual

Repeat Playback—Automatic Cyclical Playback
Repeat Playback—Automatic Cyclical Playback Between Selected Two
Between Selected Two Points
Points
20
Chapter 2 Playback
This unit has a repeat playback function, for automatic cyclical playback
of recording between selected top and end points.
Proceed as follows to perform repeat playback.
1
Set the desired repeat top and end points.
The points which can be selected for repeat top and end points and the
setting methods are indicated in the following table.
Repeat top point Repeat end point Setting method
Top (or beginning) End of tape
of tape
End of recording
Point selected by Point selected by
user (point A) user (point B)
There are no restrictions on how to combine repeat top and end points.
(For example, top of tape and point B can be selected. )
2
Set "REPEAT MODE" under the REPEAT FUNCTION menu item to
ON. (See page 32.)
The REPEAT indicator lights.
3
Press the MENU to close the menu.
4
Press the PLAY button.
The tape is cued up to the repeat top point set in step 1 and playback
starts. The unit repeats playback between the repeat top and end points
set in step 1.
To perform power-on playback
Turn the POWER switch off after checking that the REPEAT indicator
lights and again turn the POWER switch on.
The tape is cued up to the repeat top point set in step 1 and playback starts.
The unit repeats playback between the repeat top and end points set in step
1.
Note
When the REPEAT indicator lights, pressing the PLAY button or turning
the POWER switch ON cues up the repeat top point instead of starting
normal playback. If you want to carry out normal playback, set "REPEAT
MODE" under the REPEAT FUNCTION menu item to OFF.
Make settings for "REPEAT TOP"
and "REPEAT END" under the
REPEAT FUNCTION menu item (see
page 32).
See the next section "Set Points A
and B for Repeat Playback".