Table of Contents
Advertisement
Chapter 5
Configuring Channelized mode for the Cisco PA-MC-2T3+
The following example is for a PA-MC-2T3+ in port adapter slot 1 of a VIP in a Cisco 7500 series router.
Router(config-controller)# end
Router# show controller T3 1/1/0
T3 1/1/0 is administratively down.
Router# show controller T3 1/1/1
T3 1/1/1 is administratively down.
Save the shutdown configuration to nonvolatile memory.
Step 5
Router# copy running-config startup-config
Replace the port adapter in the slot. See the
Step 6
for more information.
Reenable the port adapter by doing the following:
Step 7
a.
b.
c.
For complete descriptions of software configuration commands, refer to the publications listed in the
"Related Documentation" section on page
Configuring a Channelized T3 Link
If you installed a new PA-MC-2T3+ or if you want to change the configuration of an existing
PA-MC-2T3+ link, you must enter the privileged level of the EXEC command interpreter and then use
the configure command. If you replace a PA-MC-2T3+ that was previously configured, the system
recognizes the new PA-MC-2T3+ link and brings it up in its existing configuration.
After you verify that the new PA-MC-2T3+ is installed correctly (the enabled LED goes on), use the
privileged-level configure command to configure the new interface. Be prepared with the information
you need, such as the following:
•
•
The configure command requires privileged-level access to the EXEC command interpreter, which
usually requires a password. Contact your system administrator if necessary to obtain EXEC-level
access.
OL-3526-05
Repeat Step 3 to reenable an interface but substitute the no shutdown command for the shutdown
command.
Repeat Step 4 to verify that the interfaces are in the correct state and no longer shut down. Use the
show controller T3 command.
Repeat Step 5 to write the new configuration to memory.
Use the copy running-config startup-config command.
Protocols you plan to route on each new interface
IP addresses, if you plan to configure the interfaces for IP routing
"Port Adapter Removal and Installation" section on page 3-4
viii.
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
Configuring a Channelized T3 Link
5-3
Advertisement
Table of Contents
