Table of Contents
Advertisement
Chapter 5
Configuring Channelized mode for the Cisco PA-MC-2T3+
Image text-base: 0x60010910, data-base: 0x60320000
Using the show interfaces Command
The show interfaces command displays status information (including the physical slot and interface
address) for the interfaces you specify. Following are examples for some of the supported platforms; the
examples specify serial interfaces.
For complete descriptions of interface subcommands and the configuration options available for
Cisco 7200, Cisco 7301 routers, the Cisco 7304 PCI Port Adapter Carrier Card in Cisco 7304 routers,
Cisco 7401ASR, and VIP interfaces, refer to the publications listed in the
section on page
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Cisco 7200 Series Routers
Following is an example of the show interfaces command for Cisco 7200 series routers. In this example,
the port adapter is in slot 1 of the Cisco 7200 series router:
Cisco 7301 Router
Following is an example of the
information for each interface is omitted. (Interfaces are administratively shut down until you enable
them.)
outer# show interfaces
GigabitEthernet0/0 is up, line protocol is up
Hardware is BCM1250 Internal MAC, address is 0005.dd2c.7c1b (bia 0005.dd2c.7c1b)
Internet address is 10.1.3.153/16
OL-3526-05
--Boot log end--
viii.
Router# show interfaces serial 1/0/1:0
Serial1/0/1:0 is up, line protocol is up
Hardware is 2CT3+
Internet address is 1.1.1.1/24
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
Last input 19:04:01, output 12:49:52, output hang never
Last clearing of "show interface" counters 13:09:09
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
18722 packets input, 2134308 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
82 input errors, 0 CRC, 0 frame, 82 overrun, 0 ignored, 0 abort
18722 packets output, 2134308 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffers copied, 0 interrupts, 0 failures
8 carrier transitions no alarm present
Timeslot(s) Used: 1-24, Transmitter delay is 0 flags, transmit queue length 5
non-inverted data
command for Cisco 7301 routers. Most of the status
show interfaces
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
Checking the Configuration
"Related Documentation"
5-33
Advertisement
Table of Contents
