Table of Contents
Advertisement
Port Adapter Removal and Installation
Cisco 7200 VXR Routers Port Adapter Jacket Card
The Port Adapter Jacket Card is used in the I/O controller slot of a Cisco 7200 VXR router with either
an NPE-G1 or NPE-G2 installed, and allows a port adapter to be installed in it. Both the NPE-G1 and
NPE-G2 incorporate I/O controller functionality, so that with either network processing engine the I/O
controller slot is available. The NPE-G1 and NPE-G2 have a third dedicated peripheral component
interconnect (PCI) bus that provides additional bandwidth to the chassis. The third PCI bus allows a port
adapter with a high bandwidth point requirement to be used with the Port Adapter Jacket Card in the I/O
controller slot.
Online insertion and removal (OIR) is not supported on the Port Adapter Jacket Card. OIR is supported
Note
on the port adapter. You must have the chassis powered off to install or remove the Port Adapter Jacket
Card.
Figure 2
1
2
3
1
2
3
Table 1
LED
ENABLE
PWR (power)
Use the following information to install a port adapter into an installed Port Adapter Jacket Card. For
information on installing the Port Adapter Jacket Card into a Cisco 7200 VXR router, see the
Port Adapter Jacket Card Installation Guide.
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
3-6
Port Adapter Jacket Card Faceplate
4
Captive installation screw
ENABLE LED
PWR (power) LED
Port Adapter Jacket Card LEDs
Color
Green
Off
Green
Off
Chapter 3
5
4
Handle
5
Port adapter slot
Indicates
Port Adapter Jacket Card is enabled for operation.
Port Adapter Jacket Card is not enabled for operation.
Port Adapter Jacket Card is receiving power.
Port Adapter Jacket Card is not receiving power.
Removing and Installing Port Adapters
1
PORT ADAPTER JACKET CARD
4
OL-3526-05
Advertisement
Table of Contents
