Performing A Basic Serial Interface Configuration - Cisco PA-MC-2T3+ Installation And Configuration Manual

Configuring a Channelized T3 Link
•
This completes the procedures for configuring and testing T1 lines.
To check your configurations using show commands, proceed to the
section on page
configuration:
•

Performing a Basic Serial Interface Configuration

Note The Cisco 7200 VXR Port Adapter Jacket Card requires no configuration. Configure a port adapter in it
as you would any other port adapter.
Following are instructions for a basic configuration: enabling an interface and specifying IP routing. You
might also need to enter other configuration subcommands, depending on the requirements for your
system configuration and the protocols you plan to route on the interface. For complete descriptions of
configuration subcommands and the configuration options available for serial interfaces, refer to the
appropriate software documentation.
In the following procedure, press the Return key after each step unless otherwise noted. At any time you
can exit the privileged level and return to the user level by entering disable at the prompt as follows:
Enter configuration mode and specify that the console terminal is the source of the configuration
Step 1
subcommands, as follows:
Router# configuration terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Specify the first interface to configure by entering the interface serial subcommand, followed by the
Step 2
interface address of the interface you plan to configure.
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
5-24
The example that follows is for a port adapter in slot 1 of the Cisco 7200 series routers:
Router(config)# controller T3 1/0
Router(config-controller)# no t1 10 bert
5-26; otherwise, proceed to the following sections to perform a basic interface
Performing a Basic Serial Interface Configuration, page 5-24
Router# disable
Router>
Chapter 5 Configuring Channelized mode for the Cisco PA-MC-2T3+
"Checking the Configuration"
Table 5-2 provides examples.
OL-3526-05