Checking the Configuration
Note
To enable and display remote performance reports, see the
Line" section on page
Displaying Remote Performance Reports
To display performance data from the remote T1 equipment, use the following command:
show controllers T3 0/1/0 remote performance.
Examples follow:
•
•
router# show controllers t3 3/0 remote performance tabular
T3 3/0 is down.
CT3 H/W Version : 0.1.1, CT3 ROM Version : 0.95, CT3 F/W Version : 1.3.2
FREEDM version: 1, reset 0
T1 1 - Remote Performance Data (Not available)
T1 2 - Remote Performance Data (Not available)
T1 3 - Remote Performance Data (Not available)
T1 4 - Remote Performance Data (Not available)
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
5-42
5-13, and the
The example that follows is for a port adapter on a VIP in interface processor slot 1:
Router# show controllers T3 1/1/0 remote performance
T3 1/1/0 is up.
Hardware is 2CT3+ single wide port adapter
CT3 H/W Version : 1.0.0, CT3 ROM Version: 1.1, CT3 F/W Version: 0.23.0
FREEDM version: 1
T1 1 - Remote Performance Data
Data in current interval (356 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs
0 Unavail Secs
Data in Interval 1:
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
2 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs
0 Unavail Secs
Data in Interval 2:
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs
0 Unavail Secs
Total Data (last 2 15 minute intervals):
1 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
2 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs
0 Unavail Secs
T1 2 - Remote Performance Data
.
.
.
(additional displayed text not shown)
The example that follows is for a port adapter in slot 3 of a Cisco 7200 series router:
Hardware is 2CT3+ single wide port adapter
Chapter 5
Configuring Channelized mode for the Cisco PA-MC-2T3+
"Setting the FDL Configuration for a T1
"Displaying Remote Performance Reports" section on page
5-42.
OL-3526-05