Table of Contents
Advertisement
Chapter 5
Configuring Channelized mode for the Cisco PA-MC-2T3+
Table 5-2
Examples of the interface serial Subcommand
Platform
Cisco 7200 series routers
Cisco 7301 routers
Cisco 7304 PCI Port Adapter Carrier
Card in a Cisco 7304 router
Cisco 7401ASR routers
VIP in Cisco 7000 series or Cisco 7500
series routers
Assign an IP address and subnet mask to the interface (if IP routing is enabled on the system) by using
Step 3
the ip address subcommand, as in the following example:
Router(config-if)# ip address 10.0.0.0 10.255.255.255
Add any additional configuration subcommands required to enable routing protocols and set the
Step 4
interface characteristics.
Reenable the interfaces using the no shutdown command. (See the
Step 5
Adapter" section on page
Step 6
Configure all additional port adapter interfaces as required.
After including all of the configuration subcommands to complete your configuration, press
Step 7
Ctrl-Z—hold down the Control key while you press Z—or enter end or exit to exit configuration mode
and return to the EXEC command interpreter prompt.
OL-3526-05
Command
interface serial, followed by
port-adapter-slot/T3-port/
T1-line-number:channel-group
number
interface serial, followed by
port-adapter-slot/T3-port/
T1-line-number:channel-group
number
interface serial, followed by
port-adapter-slot/T3-port/
T1-line-number:channel-group
number
interface serial, followed by
port-adapter-slot/T3-port/
T1-line-number:channel-group
number
interface serial, followed by
interface-processor-slot/
port-adapter-slot/
T3-port/T1-line-number:
channel-group number
5-2.)
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
Configuring a Channelized T3 Link
Example
The example is for T3 port 0, T1 1,
channel group 0 of a
port adapter in port adapter slot 6.
Router(config)# interface serial
6/0/1:0
Router(config-if)#
The example is for T3 port 0, T1 1,
channel group 0 of a
port adapter in port adapter slot 1.
Router(config)# interface serial
1/0/1:0
Router(config-if)#
The example is for T3 port 0, T1 1,
channel group 0 of a port adapter in a Cisco
7304 PCI Port Adapter Carrier Card in
module slot 3 of a Cisco 7304 router.
Router(config)# interface serial
1/0/1:0
Router(config-if)#
The example is for T3 port 0, T1 1,
channel group 0 of a port adapter in port
adapter slot 1.
Router(config)# interface serial
1/0/1:0
Router(config-if)#
The example is for T3 port 0, T1 1,
channel group 0 of a port adapter in port
adapter slot 1 of a VIP in interface processor
slot 4.
Router(config)# interface serial
4/1/0/1:0
Router(config-if)#
"Replacing an Existing Port
5-25
Advertisement
Table of Contents
