Configuring an Unchannelized T3 Link
Configuring the T3 Controller
This section provides procedures and examples for configuring the T3 controller on the PA-MC-2T3+,
and includes information on the following topics:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Selecting a T3 Controller
You must enter the following controller command, before any other configuration commands, to select
the T3 controller you want to configure:
controller T3 interface-processor-slot/port-adapter-slot/T3-port for Cisco 7500 series router
controller T3 chassis-slot/T3-port for Cisco 7200 series router
controller T3 chassis-slot/T3-port for Cisco 7301 series router
controller T3 chassis-slot/T3-port for Cisco 7401ASR router
Examples of selecting the T3 controller follow:
•
•
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
4-4
Selecting a T3 Controller, page 4-4
Sending a BER Test Pattern on the T3 Line, page 4-13
Viewing the Results of a BER Test, page 4-14
Terminating a BER Test, page 4-16
The example that follows is for a port adapter on a VIP in interface processor slot 1:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# controller T3 1/0/0
Router(config-controller)#
The example that follows is for a port adapter in slot 1 of the Cisco 7200 series routers:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# controller t3 1/0
Router(config-controller)#
Chapter 4
Configuring Unchannelized mode for the Cisco PA-MC-2T3+
OL-3526-05