Honeywell OneWireless XYR 6000 User Manual page 39

Transmitter Wireless Builder display
display
BAD RADIO EEPROM SPI
EEPROM Communication Failure
RADIO WDT WDT Reset Occurred
RESET
BAD RADIO Radio Circuitry Failure
The following status messages have multiple meanings. Refer to Wireless Builder Device Status for exact cause.
E FAIL A/D Failure
E FAIL Electronics Failure
E FAIL* NVM Fault*
E FAIL* Program Memory Fault*
E FAIL* RAM Fault*
INP FAIL Input 1 Failure
INP FAIL Input 2 Failure
Rev. 3 OneWireless XYR 6000 Temperature and Temperature/Discrete Input Transmitter User's Manual
6/24/08
Definition
Radio EEPROM SPI
Communication failure
Radio Watch Dog
Timeout detected
Radio circuitry has failed
Diagnostics detected
defect with Analog to
Digital Converter.
Electronic Failure
detected on Sensor
Board. Could be caused
by one of the status
items marked by *.
Startup diagnostics
detected defect in
Sensor Non-Volatile
Memory
Startup diagnostics
detected defect in
Sensor Read Only
Memory
Startup diagnostics
detected defect in
Processor Random
Access Memory
Input 1 error
Input 2 error
5. Operation
5.3. Transmitter PV display
What to do
The radio will not be able to
perform firmware upgrades but will
operate normally using installed
code. Replace sensor module.
See page 36.
Restart both the radio and sensor.
If condition persists, replace
sensor module. See page 36.
The radio processor detected error
on internal radio circuitry. Replace
sensor module. See page 36.
Replace sensor module. See page
36.
Restart both the radio and sensor.
If condition persists, replace
sensor module. See page 36.
Replace sensor module. See page
36.
Replace sensor module. See page
36.
Replace sensor module. See page
36.
Check input 1 connection.
Check input 1 configuration.
Restart the sensor. If condition
persists, replace sensor module.
See page 36.
Check input 2 connection.
Check input 2 configuration.
Restart the sensor. If condition
persists, replace sensor module.
See page 36.
25