Device Description (Dd); Configuring A New Device; Sensor Calibration - Siemens sitrans LR200 Instruction Manual

Device Description (DD)

You can locate the DD in Device Catalog, under Sensors/Level/Echo/Siemens Milltronics/
SITRANS LR200. Check the product page of our website at:
https://pia.khe.siemens.com/index.asp?Nr=7427, under Downloads, to make sure you have
the latest version of SIMATIC PDM, the most recent Service Pack (SP) and the most
recent hot fix (HF). If you need to install a new DD see

Configuring a new device

1. Check that you have the most recent DD, and if necessary download it from the
product page listed under Device
computer, and extract the zipped file to an easily accessed location. Launch SIMATIC
PDM – Manager Device Catalog, browse to the unzipped DD file and select it.
2. Set Device Address (default: 126) via the handheld programmer. (See
on page 43 to use SIMATIC PDM.)
• Press RIGHT Arrow
• Navigate to COMMUNICATION (5) > DEVICE ADDRESS (5.1)and press RIGHT
Arrow
• If required, Press RIGHT Arrow
press RIGHT Arrow
parameter view.
• Press Mode
3. Launch SIMATIC Manager and create a new project for LR200. Application Guides
for setting up PROFIBUS PA devices with SIMATIC PDM.can be downloaded from
the product page of our website at: https://pia.khe.siemens.com/index.asp?Nr=7427.
4. Open the menu Device – Device Reset and click on OK to perform a reset to Factory
Defaults.
5. After the reset is complete upload parameters to the PC/PG.

Sensor calibration

Calibrate the device via the Quick Start Wizard. (See
7ML19985JR01 SITRANS LR200 (PROFIBUS PA) – INSTRUCTION MANUAL
Description (DD)
to activate PROGRAM mode and open menu level 1.
to open parameter view.
to accept it. The LCD displays the new value in
to exit PROGRAM mode.
Configuring a new device
above. Save the files to your
to open Edit mode. Key in a new value and
Quick Start
on page 30.)
below.
Set Address
Page 29