Seq Edit Mode - Korg Minilogue XD Owner's Manual

Button 13 (INITIALIZE)
Initialize Program
This initializes the currently selected program.
Turn the PROGRAM/VALUE knob until "Press WRITE" is indicated in the display.
Press the WRITE button to initialize the program. The display will indicate the message "Initial-
ized".
Button 14 (DUMP)
Program Dump
Transmits the SysEx data for the currently selected program to another minilogue xd, MIDI data
filer, computer or other compatible device that is connected to this instrument.
Turn the PROGRAM/VALUE knob until "Press WRITE" is indicated in the display.
Press the WRITE button to send a SysEx program dump from the minilogue xd's MIDI OUT and
USB B port. The message "Transmitting" will be shown in the display during data transmission.

SEQ EDIT mode

Button 5 (BPM)
BPM
This parameter sets the tempo of the sequencer in beats per minute (BPM).
Button 6 (SEQ PARAMETER)
This group provides control of various sequencer timing and resolution parameters such as Gate
Time, Swing, etc.
Step Length
Step Length allows you to set the number of steps used by the Step Sequencer.
Turn the PROGRAM/VALUE knob to change the number of steps during step recording.
Step Resolution
The step resolution is used to set the length of each step in the step sequencer.
1/16: A single step will be set to the length of a sixteenth note.
1/1: A single step will be set to the length of one measure. Use this when you want to play long
chords.
Swing
The Swing parameter adjusts the intensity of the swing. When the voice mode is "ARP", the value
set here is also used for the arpeggiator swing.
Default Gate Time
The Gate Time is the default value used for each step recorded using the step sequencer. Lower
values are more staccato, higher values have a longer gate time. When the voice mode is "ARP",
the value set here is also used for the arpeggiator gate time.
[10.0...300.0]
[1...16]
[1/16, 1/8, 1/4, 1/2, 1/1]
[–75%...0%...+75%]
[0%...100%]
37