Omron ERT1 Series Operation Manual page 90

Environment-resistive Slave Units
Output Power Indicator
Setting the Node
Address
70
Indicator Color
7-B Lit yellow.
Not lit.
Lit red.
Flashing red.
8-A Lit yellow.
Not lit.
Lit red.
Flashing red.
8-B Lit yellow.
Not lit.
Lit red.
Flashing red.
This indicator shows the status of the output power supply.
AUX (exter- Lit green.
nal power
Not lit.
supply)
The rotary switches are used to set the lower digits of the IP address.
Setting method Two hexadecimal digits
Setting range 01 to FE
Rotary Switch Settings
00 hex: BOOTP or tool setting enabled (factory setting)
01 to FE hex: Setting on rotary switches is lower 8 bits of IP address. (De-
fault setting of upper 24 bits: 192.168.250.)
FF hex: Restores default setting.
(To restore the default setting, set the switches to FF hex, cycle the power
supply, and then set the switches to 00 hex.)
Status Meaning (main error)
Output 13 is ON.
Output 13 is OFF.
Output 13 is short-circuited.
Output 13 is disconnected.
Output 14 is ON.
Output 14 is OFF.
Output 14 is short-circuited.
Output 14 is disconnected.
Output 15 is ON.
Output 15 is OFF.
Output 15 is short-circuited.
Output 15 is disconnected.
Output power is being supplied.
Output power is not being supplied.
Section 5-2