Environment-Resistive Slave Units; Mounting In Control Panels; Environment-Resistive Terminals With 16 Transistor Inputs (Ip67) - Omron ERT1 Series Operation Manual

Environment-resistive Slave Units

5-2

Environment-resistive Slave Units

5-2-1

Mounting in Control Panels

Installation Direction
5-2-2

Environment-resistive Terminals with 16 Transistor Inputs (IP67)

Input Specifications
Byte
offset
Bit 07 06
2 Power or Load Short-circuit Detection Flags for Terminal Block 2
07 06
3 Power or Load Short-circuit Detection Flags for Terminal Block 2
15 14
4 Disconnection Flags for Terminal Block 1
07 06
5 Disconnection Flags for Terminal Block 1
15 14
6 Disconnection Flags for Terminal Block 2
07 06
7 Disconnection Flags for Terminal Block 2
15 14
The Environment-resistive Slave Units are designed to be easily connected
with M12 connectors that lock by turning them 1/8 of a turn for less wiring.
Use screws to mount a Waterproof Terminal in a control panel. These Termi-
nals cannot be mounted on a DIN Track.
Drill the mounting holes in the control panel according to the dimensions
shown in the dimensions diagrams and secure the Terminal with M5 screws.
The appropriate tightening torque is 1.47 to 1.96 N⋅m.
The Terminal can be mounted in any direction. Any one of the following 6
directions is acceptable.
ERT1-HD16CH-1
Item
Input points
Internal I/O common
ON voltage
OFF voltage
OFF current
Input current
ON delay time
OFF delay time
Number of circuits per
common
Isolation method
Input indicators
Power supply short-circuit
protection
Disconnection detection
Data
05 04 03
05 04 03
13 12 11
05 04 03
13 12 11
05 04 03
13 12 11
Specifications
16 points
PNP
15 V DC min. (between each input terminal and 0 V)
5 V DC max. (between each input terminal and 0 V)
1.0 mA max.
6.0 mA max. at 24 V DC
3.0 mA max. at 17 V DC
1.5 ms max.
1.5 ms max.
16 inputs/common
Photocoupler
LEDs (yellow)
Operates at 50 mA/point min.
Operates at 0.2 mA/point max.
Section 5-2
02 01 00
02 01 00
10 09 08
02 01 00
10 09 08
02 01 00
10 09 08
61