Omron ERT1 Series Operation Manual page 74

Screw-less Clamp Terminals
Output Specifications
Component Names and Functions
(2)
54
Item
Input current
ON delay time
OFF delay time
Number of circuits
Isolation method
Input indicators
Power supply short-circuit
Disconnection detection
Connection forms
Item
Output points
Internal I/O common
Output current
Residual voltage
Leakage current
ON delay
OFF delay
Number of circuits per
common
Isolation method
Output indicators
Power supply short-circuit
protection
Disconnection detection
Output handling for com-
munications errors
Connection forms
(7)
(1)
(4)
(3)
(1) Rotary Switches
These switches are used to set the node address.
Specifications
6.0 mA max. at 24 V DC
3.0 mA max. at 17 V DC
1.5 ms max.
1.5 ms max.
16 points with one common circuit
Photocoupler isolation
LEDs (yellow)
Operates at 50 mA/point min.
Operates at 0.2 mA/point max.
Screw-less clamp terminal blocks (orange)
Specification
16 points
PNP
0.5 A/point, 4.0 A/common
1.2 V max. (0.5 A DC, between each output terminal and
the V terminal)
0.3 mA max. (24 V DC, between each output terminal
and the V terminal)
0.5 ms max.
1.5 ms max.
16 outputs/common
Photocoupler
LEDs (yellow)
Operates when output current is exceeded.
Operates at current consumption of 3 mA/point max. (Not
detected at 3 mA or less.)
Select either hold or clear from Network Configurator.
Screw-less clamp terminal blocks (yellow)
(5)
Section 4-2
(8)
(6)