Omron ERT1 Series Operation Manual page 37

Overview of System Startup Procedure
Common Procedure 6-2. Setting IP Addresses Using the Network Configurator
1,2,3...
Example 1: Displaying IP Address 192.168.250.10
The IP address is displayed in decimal, flowing from right to left.
2. Set the address of the EtherNet/IP Unit
Refer to Common Procedure 4. Connecting the Network Online. For de-
tails on setting IP addresses using the Network Configurator (CIP messag-
es), refer to Common Procedure 6-2. When setting the IP addresses using
a BOOTP server, refer to Common Procedure 6-3.
3. Operation after Completing the Setting
If an F3 error occurs after setting the IP address, set the node switches on
the front of the EtherNet/IP Unit to the hexadecimal equivalent of the low-
order digit of the IP address.
−
1. Select Tools Setup TCP/IP Configuration to open the Setup TCP/IP
Configuration Dialog Box.
2. Input the IP address of the device that is to be changed in the Target IP
Address Box.
Click the Get from the Device Button to get the current settings.
Change the IP address or subnet mask, and then click the Set to the De-
vice Button. The new settings will be written to the device.
Section 2-1
17