Connector Brackets - Detroit Diesel EPA07 Series 60 DDEC VI Troubleshooting Manual

17.2 MOTOR CONTROL MODULE
17.2.1.1

Connector Brackets

The harnesses on MCM must be bracketed and held secure. The bracket design will change for
different engines as the routing is different. The 120–pin connector and the 21-pin connector
must be tie-wrapped to the brackets as shown in the following drawing for the Series 60 engine
(see Figure 17-2).
Figure 17-2 Series 60 Engine 120–pin Connector and 21–pin Connector
Tie-wrapped to Brackets
17-8
All information subject to change without notice.
Copyright © 2007 DETROIT DIESEL CORPORATION