Improper Lubricating Oil Viscosity; Lubricating Oil Replacement; Test Engine With Replaced Lubricating Oil - Detroit Diesel EPA07 Series 60 DDEC VI Troubleshooting Manual

2.2

IMPROPER LUBRICATING OIL VISCOSITY

2.2 IMPROPER LUBRICATING OIL VISCOSITY
To determine if improper lubricating oil viscosity is causing low oil pressure, perform the
following steps:
1. Acquire a lubricating oil sample from the engine oil pan.
2. Submit oil sample for an ASTM test analysis.
[a] If engine oil sample meets ASTM specifications, check to determine if lubricating
oil is diluted with fuel or coolant; refer to section 2.3.
[b] If engine oil sample did not meet ASTM specifications, refer to section 2.2.1.
2.2.1

Lubricating Oil Replacement

Perform the following steps to replace engine oil:
1. Drain and refill engine with new lubricating oil; refer to appropriate service manual,
preventive maintenance chapter.
2. Verify lubricating oil replacement, refer to section 2.2.1.1.
2.2.1.1

Test Engine with Replaced Lubricating Oil

Perform the following steps to determine if replaced lubricating oil resolved low oil pressure:
1. Connect to DDDL 7.0.
2. Start and run engine speed at 1800 rpm.
3. Check DDDL 7.0 for the for oil pressure reading.
[a] If DDDL 7.0 indicates oil pressure greater than or equal 241 kPa (35 psi) at 1800
rpm, shut down the engine and disconnect DDDL 7.0. No further troubleshooting is
required.
[b] If DDDL 7.0 indicates oil pressure less than 241 kPa (35 psi) at 1800 rpm, shut
down the engine and disconnect DDDL 7.0. Check the lubricating oil for fuel and
water dilution; refer to section 2.3.
2-4
All information subject to change without notice.
Copyright © 2007 DETROIT DIESEL CORPORATION