Kohler Escale K-25089T-S Installation Instructions Manual page 8

Note: 1. The sensing distance in the table is measured with a
30 30 cm white or black board as the reflecting 2
surface.
2. The user may set the amount of water per flush
according to the specifications of the specific toilet
and water pressure.
3. The infrared transmiting angle is 20° downward.
4. To ensure an effective flushing preformame, please
turn the adjusting bolt properly according to actual
using conditions when the product is used with toilet
(such as K-8750,etc.)
5. Do not discard the special wrench when the installation
is complete.It will be helpful for qualified maintenance
personnel to repair the outlet connection assembly
and the vacuum breaker.
6. The slurry mold is used only when install the valve
box.
7.
When the water pressure is 0.10 ~ 0.55 MPa, If sometimes
splashs, you can reduce the water flow. When adjusting,
remove the sensor cover and turn the adjusting bolt for
water flow till good flushing and no splash.
2
注意： 1.
2.
3.
4.
5.
6.
7.
水流调节
流动水压在0.10~0.55MPa时，如有溅出现象可适当调小
水流速度。调节时取下面板，顺时针方向旋动水流调节栓
至能冲洗干净而又不溅出即可。
右旋
30cm X 30cm
20° 。
K-8750
1350669-T01-A