Kohler Escale K-25089T-S Installation Instructions Manual page 21

IMPORTANT CONSUMER INFORMATION 用户须知
I
Consumer Responsibilities
1. Do not attack the sensor.
2. Do not directly flush the sensor with water. The sensor is
an electronic instrument.
3. Do not let sunlight or other light source enter or be
reflected into Sensor Window.
4. Do not hang on the opposite wall any reflective items or
install light/electronic sensor such as toilet flushing sensor.
5. Do not make Sensor Window near strong ultraviolet or
electromagnetic field.
6. Keep the sensor window clean.
The sensor cover can be cleaned by soft rag with neutral
liquid detergent.
Do not use eradicator, abrasive powder or oil, acid or alkali
liquid detergent.
Do not spray air freshener, disinfectant or other kinds of
odious removing, cleaning organic liquid to the sensor
directly.
7. Urinal is designed for use with potable water. Avoid water
that includes a lot of contaminants or acid/alkali water and
impure water.
8. When AC power unit is connected to 220V AC power
supply, corresponding protective measures should be
taken.
9. Please confirm no water penetration at the connection
area of AC wire, and the connection area is not easy to be
affected by damp.
10. Don t connect power unit to AC power supply until the '
sensor installation is finished.
11. The head AC power supply must be protected with
appropriate fuse.
12. Please confirm the AC power supply and water supply
should be shut off before maintaining the products with
AC power related.
13. All electrical connection must be compliance with related
regulation and codes.
14. All installation staff should be well familiar with installation
instruction.
15
用户责任
请勿敲击感应窗口。
1.
感应器为电子器具，请勿直接用水冲洗。
2.
避免阳光或其他光源直接或反射进入感应窗口。
3.
请勿在感应器正面墙壁挂贴易反射的物体或安装光电感应器
4.
（如大便自动感应冲洗器）。
请勿靠近强烈紫外线或电磁场。
5.
保持感应窗口清洁。
6.
窗口外壳可用蘸有中性清洁剂的软布擦洗。
禁止使用去污粉、研磨粉及油类、酸性类、碱性类清洁剂。
禁止直接对感应窗口喷洒空气清新剂、消毒液、或其他除臭、清
洁类有机溶剂。
使用水源为自来水或可供饮用井水。
7.
避免使用含有杂志较多或带有酸、碱性的处理水或未加工处理的
水。
将交流电源盒接入220V电源时，应采取相应的防卫措施。
8.
应确保交流导线连接处无水渗入以及不易受潮。
9.
务必在感应器安装完毕后，才向交流电源盒供电。
10.
交流电的总电源必须有合适的熔断丝加以保护。
11.
维修交流供电型的产品时，必须首先断开交流电源并关闭水源。
12.
所有电路连接必须符合相关规范和条例要求。
13.
所有参与安装人员都必须熟知安装说明。
14.
1350669-T01-A