Registration Adjust - Sony Screen Management System User Manual

the Projector Service Manual for additional
information.
When complete click Next. Step 3 of 4 appears.
3
Tap to adjust the Z axis again.
During this step you manually optimize the Z Axis
after completing the X and Y Axis adjustments.
Adjust the Z-Axis. Alternately touch and hold the
Plus or Minus buttons while observing the
reading on the Status Display. Attempt to adjust the Z-
Axis for an average peak level.
Cancel
When complete click Next. Step 4 of 4 appears.
4
Lamp Axis Adjustment is complete.
The wizard saves the adjustments, restores the original
Lamp Power and sets the Test Patter to OFF.

Registration Adjust

Previously, adjustments to the Red, Green, and Blue image
positioning (X/Y Axis) was realized using the SRX
Controller application. This adjustment is also available
from the Projectionist Terminal. Access to this feature uses
the pre-defined Theater Setup login "trsetup" thus insuring
Auto Next
that these adjustments are carried out by only qualified
personnel.
Caution
Prior to performing
Registration Adjustment
set the Projector to ON
mode. To set On mode,
tap Menu, tap Projector,
tap Power, and then tap
ON. Make sure the
Douser is set to OFF.
Allow a minimum of 30
minutes warm-up to
insure that the imaging
devices have reach their
operating temperature.
Also, prior to performing
Registration Adjustment,
Tap Registration Adjust
verify that focus is
optimized. To adjust the focus, recall the correct lens focus
by selecting an appropriate FUNCTION or re-adjust using
FUNCTION SETUP (Role restricted).
To perform Registration Adjustment, tap Menu, tap
Projector, and then tap Registration Adjust. The
Registration Adjustment screen appears.
Adjustments made during the Registration Adjust process
are applied immediately to the projector. You must be able
to view the auditorium screen in detail as picture
movement is in pixel increments.
1
To begin the Registration Adjustment process, select
the Start registration adjustment option and then tap
Next.
The Registration Adjustment screen containing the
Horizontal and Vertical adjustment controls appears.
Start registration...
2
Specific Test Patterns are used during the Registration
Adjustment process.
Tap Menu
Tap Projector
Next
Theater Setup
77