Refresh Sms Server - Sony Screen Management System User Manual

Replacement, setting of FUNCTION names, and
associating a specific Color Space with a FUNCTION.
The SRX Controller is a stand alone software application
that allows a computer to directly control the SRX-R320.
This control is via the serial connector located on the rear
panel of the projector just below the circuit breakers. When
adjustments are made using the SRX Controller the
changes and settings are not automatically transferred to
the SMS Server and therefore, do not appear on the
Projectionist Terminal. A REFRESH button is available
on the PROJECTOR MAINTENANCE pane which
causes the SMS Server to query the Projector and make the
refreshed data available to the Projectionist Terminal.
Executing the Calibrate Luminance function should be
done with care as this can affect the Lamp Power range and
cause the brightness of the image to change. Selecting a
Test Pattern will interrupt the presentation image.
Refresh Projector Data
Calibrate Luminance
Operations available on the Maintenance screen are;

• REFRESH SMS Server

The Refresh Projector Data button reloads the SMS
Server application with all the Projector data.
The Refresh function is used whenever the SRX
1
Controller has been connected directly to the
projector to accomplish maintenance operations,
e.g., bulb replacement. After the SRX Controller has
been disconnected from the projector you should
refresh the SMS Server (tap Refresh Projector Data)
which will update the SMS Server with any changes
made using the SRX Controller application.
Note
Refresh Projector Data is a maintenance function.
Refreshing the SMS Server with new data from the
projector takes some time and may result in
unexpected projector operation should this action be
taken during Show presentation.
1.The SRX Controller is typically a PC running the SRX
Controller application and connected to the projector
using a serial data line.
LAMP INFORMATION
• LAMP INFORMATION
Displays the Serial Code, Lamp Serial Number and the
maximum rated Lamp Power.
• LUMINANCE ADJUSTMENT
– Adjust (Luminance Calibration)
Allows you to calibrate the Luminance vs. Lamp
Power table data stored in the projector.
Note
This function is only available when the Lamp Control
Mode of the projector is set to "Luminance". Because the
default Lamp Control Mode setting is "Lamp Power", the
function should normally not be used. The SRC Controller
application can be used to set the projector to the
Luminance mode.
Refresh SMS Server
In the REFRESH SMS Server group you can manually
force the SMS Server application to refresh the SMS
Server with Projector stored data.
Normally the SMS Server is the device controlling the
Projector and saves any changes made by the SMS Server
to the Projector as they are made. However, if a projector
setting was changed with the SRC Controller, this will not
be detected by the SMS Server. If the SRX Controller was
used for maintenance purposes or similar, and any change
was made to the projector settings, the SMS Server data
must be refreshed manually.
REFRESH SMS Server
To refresh the Projector Data, tap Menu, tap
Maintenance, tap Projector, and then tap Refresh
Projector Data in the REFRESH SMS Server group.
Refresh Projector Data
Maintenance
61