Lamp Axis Adjust; Adjust X, Y, & Z Lamp Axis - Sony Screen Management System User Manual

The Lamp Install "wizard" (initial screen shown below)
begins the process of entering the Lamp Serial code for the
new (replacement) lamp.
Cancel
To proceed to Serial Code entry click Next.
The Lamp Serial Code is included with the replacement
(new) lamp. To enter the Lamp Serial Code tap the text
box. An on-screen numeric keyboard appears.
Cancel
Using the on-screen keyboard, tap the numeric Serial
Code and then tap Enter. The Serial Code is validated for
correct format and Next becomes available. Tap Next to
continue to Lamp Axis Adjust.
To cancel Serial Code entry, if any entry has been made
into the Serial Code text box tap Clr, then tap Enter, and
then tap Cancel. If no entry has been made into the Serial
Code text box simply tap Enter and then tap Cancel. In
either case, a popup confirmation appears. Tap Yes and the
Lamp Install Wizard closes.
Caution
The lamp should be replaced prior to exceeding
recommended operating hours. Refer to the projector
documentation for additional information.

Lamp Axis Adjust

The Lamp Axis Adjust entry feature has been made
available under the "trsetup" login and combined with
other functions, i.e., Lamp Serial Code entry and Image
Registration
using the SRX Controller application.
• Lamp Axis Adjust is only available through the
• If power to the projector is turned off during Lamp Axis
Adjust X, Y, & Z Lamp Axis
Next
Installation of a new lamp is a multistep process and once
the lamp is installed the Lamp Axis (X, Y, and Z) must be
adjusted for optimum light output.
Normally, the Lamp
Axis Adjust process is
performed following
Lamp Installation and
Serial Code Text Box
setting the Lamp Serial
Code. In this case the
Lamp Install wizard will
automatically progress
from Serial Code entry
to Axis Adjust.
However, if the axis
adjustment cannot be
performed at the time of
installation you can
directly access the Lamp
Axis Adjust steps using
the "trsetup" login.
The Wizard automatically checks for the correct Projector
Next
Power mode of operation, e.g., Lamp Axis Adjust requires
LAMP ON mode. For Lamp Axis adjustment the Lamp
should be on for an amount of time (approximately 5
minutes) to insure stability of the lamp output. A
countdown timer has been included to indicate how much
time remains before axis adjustment can begin.
1
. Previously, Lamp Axis Adjust required
Caution
pre-defined Theater Setup login thus insuring that this
adjustment is only done by qualified personnel.
Adjust, restart the SMS.
Tap Lamp Axis Adjust
1.In previous versions, Image Registration required use of
the SRX Controller application.
Tap Menu
Tap Projector
75
Theater Setup