Naming Inputs; Start Playback; Adjust The Volume - Sony HT-DDW5500 Operating Instructions Manual

Selected input
[Display]
DVD
[DVD]
SAT
[SAT]
TV
[TV]
SA-CD/CD
[SA-CD/CD/
CD-R]*
TUNER
[FM or AM band]
* "SA-CD/CD/CD-R" scroll across the
display, then "SA-CD/CD" appears.
2
Turn on the component and

start playback.

3
Press MASTER VOL +/– to

adjust the volume.

You can also use MASTER VOLUME on
the receiver.
To activate the muting function
Press MUTING.
The muting function will be canceled when
you do the following.
• Press MUTING again.
• Increase the MASTER VOLUME.
• Turn off the receiver.
To avoid damaging your
speakers
Before you turn off the receiver, be sure to turn
down the volume level.
To listen to the subwoofers
• You can use the SUBWOOFER VOLUME
on the power amplifier to adjust the volume
of the subwoofers.
• Set the volume level to suit your preference
according to the selected input as slight
adjustments may enhance the sound.
• If you set the subwoofer volume to
maximum, extraneous noise may be heard
depending on the source you are playing.
36
GB
Components that can
be played back
DVD player, etc.,
connected to DVD jack
Satellite tuner, etc.,
connected to the SAT jack
TV, etc. connected to TV
jack
Super Audio CD/CD
player, etc., connected to
the SA-CD/CD/CD-R jack
Built-in radio tuner

Naming inputs

You can enter a name of up to 8 characters for
inputs and display it on the receiver's display.
This is convenient for labeling the jacks with
the names of the connected components.
1
Press the input button to select
the input you want to create an
index name for.
You can also use INPUT SELECTOR on
the receiver.
2
Press AMP MENU.
"1-LEVEL" appears on the display.
3
Press V/v repeatedly to select
"7-SYSTEM".
4
Press or b to enter the
menu.
5
Press V/v repeatedly to select
"NAME IN".
6
Press or b to enter the
parameter.
The cursor flashes and you can select a
character.
7
Press V/v to select a character,
then press B/b to move the
cursor to the next position.
If you made a mistake
Press B/b until the character you want to
change flashes, then press V/v to select
the correct character.
Tips
• You can select the character type as follows
by pressing V/v.
Alphabet (upper case) t Numbers t
Symbols
• To enter a blank space, press b without
selecting a character.
8
Press .
The name you entered is registered.