Sony Screen Management System User Manual page 76

The Lamp Axis Adjust "wizard" (initial screen shown
below) begins the process of entering the Lamp Serial code
for the new (replacement) lamp.
Cancel
To proceed to Lamp Axis Adjust click Next. Step 1 to 4
appears.
1
The Lamp Axis Adjustment wizard will automatically
establish the Lamp at 100% Power and select the
"Black" test pattern.
A countdown timer is also displayed on this screen By
waiting for this timer to expire before continuing the
output of the lamp will have stabalized.
Countdown
Test Pattern
Timer
Setting
Cancel
Once the countdown has expired, click Next. Step
2 of 4 appears.
2
During this step you
initially adjust the Z
Axis for a maximum
indication on the
Projector Status Display
located in the upper-
right corner of the
projector's rear panel.
76
Theater Setup
To adjust the Z axis automatically, tap
obtain the optimum Z axis state.
To adjust manually the Z-Axis, tap either the Plus
or Minus
reading on the Status Display. Adjust the Z Axis for an
average peak level.
Next
Caution
• You should use
• There is a lag between when you tap either the Plus
Lamp Power
Setting
Continue to adjust the Z-Axis by alternatively tapping
the Plus or Minus button until the value observed on
the Status Display is at a peak.
Once the Z Axis
adjustment is
complete,
proceed to adjust
the X and Y
Axis. These
adjustments are
done manually
using a long
Next
5mm Allen key
through an access
hole in the rear
panel. Adjust the
X and Y Axis by
Projector
observing the
Status
Display
value on the
Status Display.
Adjust about 1/2
turn and then
observe the
results. Continue adjusting for peak reading. Refer to
button five times while observing the
Auto
Cancel
to adjust the Z axis under
normal conditions.
or Minus button and the observation of a change on
the Status Display. Also, the readings you observe
may have some variation due to the way in which the
arc in the lamp moves slightly.
X/Y Axis Adjust
to
Next
Access Hole