Sony Screen Management System User Manual page 23

To specify the Intermission location, set the target CPL to
the Play condition and tap the Stop point button at the point
where the Intermission should start. The
indication at the side shows the timecode. You can also
tap besides the Stop point button to bring up the
Enter Intermission Position popup window.
Minutes
Stop
point Hours Seconds
Restart Offset Play
Interval SPL
To enter a value, tap the
target, i.e., Hours, Minutes,
or Seconds, and then tap
(or touch-and-hold) either
Plus or Minus
button to increment the
value of the selected target.
When the desired value is
reached, tap Accept.
The Enter Intermission
Position popup window
closes. The Intermission
Position value is shown in
the Stop point field.
To specify the Restart point, set the target CPL to the Play
condition and tap the Restart point button at the point
where the Intermission should end. The
indication at the side shows the timecode. You can also
tap besides the Restart point button to bring up
the Enter Intermission Position popup window. Specify
the restart setting using the same method as described for
the Stop point.
To specify an interval duration, tap
of Interval Time. The Enter Interval Duration popup
window appears. Specify the interval setting using the
same method as described for the Stop point.
Restart Interval Close
point time
EDIT PLAYLISLT
Menu
Preview
Minutes Minus
Hours Seconds Plus
Accept Cancel
to the right
You can specify a Playlist (SPL) to be played during the
interval period. This is the Interval SPL. When you tap the
Interval SPL button, the Select Show pane appears. Tap
the desired SPL and then tap Return to Setup.
To specify an offset, tap the
Offset button. The ENTER
REWIND TIME pane
appears.
The additional command
lets you specify an absolute
offset time from the start of
the Playlist. This is done
using the ENTER OFFSET
popup window. To enter a
value, tap the target, i.e.,
Hours, Minutes, or
Seconds, and then tap (or
touch-and-hold)
either Plus or
Minus button to increment the value of the selected
target. When the desired value is reached, tap Accept. The
ENTER OFFSET popup window closes.
To check the operation of Contents (CPL) with
Intermission, tap the Preview button. The Preview
playback starts a few seconds before the start of the
Intermission (Stop point) and continues for a few seconds
past the end of the Intermission (Restart point). The
Interval CPL is played during the Intermission period.
When the setting is complete, tap the EDIT PLAYLIST
Menu button to return to the CREATE PLAYLIST pane.
Return to Setup
Rewind Close
Time
Minus Plus
Accept Cancel
Shows
23