Procedure In The Case Of Malfunctions - Gigaset 2010 Operating Instructions Manual

18.11.98

Procedure in the case of malfunctions

Symptom
No display appears
Cannot seize the dial-up line;
no dial tone
Cannot set up a radio link to
the base station – symbol on
the handset flashes.
Base station or handset does
not ring.
No connection after dialing a
call number; dial tone can
still be heard.
No connection after a con-
nection has been set up; dial
tone can still be heard.
Kap03.fm5 Gigaset 2010, UEB/engl.: A30852-X1100-E301-3-7619
Not every malfunction means that there is an actual de-
fect in your telephone. In some situations you may save
time and money if you can eliminate the cause of simple
faults yourself. The information below will help you do
this.
Cause
Handset is not switched on.
Battery is empty.
The plug on the power cord
is not connected properly.
The plug on the power cord
is not connected properly.
The dial-up line is being used
by another handset.
Handset is not registered.
The plug on the AC power
adapter cord is not connec-
ted properly.
Ringer volume is set to low.
The ring assignment is not
set correctly.
Wrong signaling method.
Wrong signaling method.
Notes on operation
Remedy
Switch on the handset.
Replace the battery with a backup
battery or recharge it.
Check the plug on the base station
and telephone socket; if necessary
remove it and plug it back in
( page 2).
Check the plug on the base station
and the socket; if necessary
remove it and plug it back in
( page 2).
Wait until the dial-up line is free.
Register the handset at the base
station ( page 49).
Check the plug on the base station
and the socket; if necessary re-
move it and plug it back in.
Adjust the base station
( page 32) or handset
( page 34) ringer volume.
Adjust the ring assignment
( page 51).
Reset the signaling method
( page 16).
Switch the signaling method
( page 18).
11