Table of Contents
Advertisement
18.7.99
Procedure in the case of malfunctions
Symptom
No display appears.
Cannot seize the dial-up line;
no dial tone.
Cannot set up a radio link to
the base station - symbol on
the handset flashes.
Base station or handset does
not ring.
No connection after dialling a
call number; dial tone can
still be heard.
With telephone systems:
no connection or wrong con-
nection after dialling from a
memory.
kap18.fm5
Important notes on putting into service and operation
Not every malfunction means that there is an actual de-
fect in your telephone. In some situations you may save
time and money if you can eliminate the cause of simple
faults yourself. The information below will help you do
this.
Cause
Handset is not switched on.
Battery is empty.
The plug on the power cord
is not connected properly.
The plug on the power cord
is not connected properly.
The plugs may have been
switched.
The dial-up line is being used
by another handset.
Handset is not registered.
The plug on the power cord
is not connected properly.
Ringer volume is set to low.
The call allocation is not set
correctly.
Wrong signalling method.
Analog trunk/MSI not en-
tered.
Gigaset 2011 Comfort, GBR: A30852-X1106-B307-1-
Remedy
Switch on the handset.
Replace the battery with a backup
battery or recharge it.
Check the plug at the base station
and telephone socket; if necessary
remove it and plug it back in
(
page 2).
Check the plug at the base station
and the 220 V/230 V socket; if nec-
essary remove it and plug it back in
(
page 2).
Wait until the dial-up line is free.
Register the handset at the base
station (
page 69).
Check the plug at the base station
and the 220 V/230 V socket; if nec-
essary remove it and plug it back
in.
Adjust the base station (
50) or handset (
volume.
Adjust the call allocation
(
page 71).
Reset the signalling method
(
page 13).
Enter analog trunk/MSI (
48).
page
page 53) ringer
page
93
Advertisement
Table of Contents
