ZyXEL Communications EMG2881-T20A User Manual page 22

Table 7 Navigation Panel: Router Mode (continued)
LINK TAB
CONFIGURATION
WAN
Management Management
WAN WAN
NAT General
Port Trigger
Passthrough
Dynamic DNS Dynamic DNS
Interface Interface
Group
Group
Wireless
Wireless Wireless
More AP
MAC Filter
Advanced
WPS
Scheduling
LAN LAN IP
Static DHCP
IPv6 LAN
Application
Bandwidth QoS General
MGMT
Queue Setup
Class Setup
UPnP UPnP
Security
IPv4 Firewall
IPv6 firewall
MAINTENANCE
General General
Password Password
Time Time Setting
Firmware Firmware
Upgrade
Upgrade
Backup/ Backup/
Restore
Restore
Chapter 3 Router Mode
FUNCTION
This screen allows you to configure ISP parameters, WAN IP address
assignment, DNS servers, the WAN MAC address, and VLAN settings.
Use this screen to enable NAT.
Use this screen to change your EMG2881-T20A's port triggering settings.
Use this screen to enable or disable the VPN passthrough feature.
Use this screen to set up dynamic DNS.
Use this screen to add a LAN interface or a VLAN ID to a new group.
Use this screen to enable the wireless LAN and configure wireless LAN and
wireless security settings.
Use this screen to configure multiple BSSs on the EMG2881-T20A.
Use the MAC filter screen to configure the EMG2881-T20A to block access to
devices or block the devices from accessing the EMG2881-T20A.
This screen allows you to configure advanced wireless settings.
Use this screen to configure WPS.
Use this screen to schedule the times the Wireless LAN is enabled.
Use this screen to configure LAN IP address and subnet mask.
Use this screen to enable the EMG2881-T20A's DHCP server.
This screen allows you to assign IP addresses on the LAN to specific individual
computers based on their MAC addresses.
Use this screen to configure the IPv6 address for the EMG2881-T20A on the LAN.
Use this screen to enable or disable QoS and set the upstream bandwidth.
Use this screen to configure QoS queue assignment.
Use this screen to configure QoS classifiers.
Use this screen to enable UPnP on the EMG2881-T20A.
Use this screen to configure IPv4 firewall rules.
Use this screen to configure IPv6 firewall rules.
Use this screen to view and change administrative settings such as system and
domain names.
Use this screen to change the password of your EMG2881-T20A.
Use this screen to change your EMG2881-T20A's time and date.
Use this screen to upload firmware to your EMG2881-T20A.
Use this screen to backup and restore the configuration or reset the factory
defaults to your EMG2881-T20A.
EMG2881-T20A User's Guide
22