Nautilus E614 Service Manual page 26

To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the wall outlet and the
machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power cord in a secure location.
Note: Your machine may not match the image. For reference only.
1. Using a 6 mm hex key and 13mm wrench, remove the indicated bolt
and washers from below the Pedal.
2. Using a 6 mm hex wrench, remove the indicated bolts from the Pedal
and Lower Handlebar Arm.
Be aware that the Handlebar Arms will be loose and may pivot
when the hardware is removed.
3. Remove the Pedal.
4. Using a 6mm hex key, loosen and remove the indicated hardware and
remove the Leg.
5. Repeat steps on opposite side.
6. Installation is the reverse procedure.
7. Discard the old parts.
8. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
13mm
6mm
26
X2
X2
6mm