Servo Motor - Nautilus E614 Service Manual

8. Use the pliers to unhook the Tension Spring (J) from the
Main Frame. Pull back and release the Magnet Arm (K) enough to
disengage it from the Motor Pulley Shaft (L).
9. Loosen and remove the two socket head bolts (M) from the
Servo Motor (A).
10. Remove the Servo Motor (A). Discard the old Servo Motor.
11. Installation is the reverse procedure. Adjust the new Servo
Motor to same position recorded in Step 3.
NOTICE: Do not touch the Potentiometer (N). Do not crimp any
cables.
12. Tie the end of the string at the hole (H) in the Mast to the end
of the Console Cable (G) on the new Servo Motor (A). Carefully pull
the cable through the hole to the top of the Mast mount. Untie the
string and discard it.
13. Reinstall the Mast, Static Handlebar, Console and Top Shroud.
(Refer to the "Replace the Shrouds" procedure.) Turn the power on.
Machine is on. Current is active. There is risk of electrical
shock.
14. Use the console to set the resistance to the highest level.
Unplug the machine.
Disconnect all power and allow to sit for 5 minutes.
15. Put the Brake Arm (K) back in position and connect the
Tension Spring (J) with the needlenose pliers.
Note: Before fully attaching the Shrouds, remove the
cardboard from between the Brake Magnet (B) and
the Flywheel (C). Power up the machine to verify that
the Magnet Arm can move freely, and that the Brake
Magnet and Flywheel do not touch at the maximum
resistance level. If necessary, refer to the "Set the
Brake Tension" procedure.
16. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
After replacing the Servo Motor, the resistance levels of the machine may
be different. The user should adjust their workout levels accordingly.
K
L
A
M
53
J