Copyright 2018 Trendnet. All Rights Reserved - TRENDnet TEW-829DRU User Manual

TRENDnet User's Guide
7. Under DHCP Server, click the Mode drop-down list and select Enabled to enable the
DHCP server on the VLAN. Click Apply to save and commit the changes.
Example: In the example below, we will enable the DHCP server on VLAN 50 and leave IP
address range and lease defaults. This will assign a DHCP IP range of 101-199 to ensure
any devices connected to this VLAN obtain IP address information via DHCP.
8. Under Reassign SSID to VLAN, next to the SSID you would like to assign the new VLAN
ID, click the Network/VID drop-down list and select the VLAN ID. Click Apply to save
and commit the changes.
© Copyright 2018 TRENDnet. All Rights Reserved.
If following the 802.1Q VLAN configuration example, a managed/web smart switch with
802.1Q VLAN support can be connected and pass VLAN 50 traffic between the router
and switch and 2.4GHz wireless SSID. Any computers or devices connecting to the
untagged VLAN ports (PVID: 50) on the managed/web smart will obtain
192.168.50.x/255.255.255.0 address settings and use the VLAN 50 IP interface
192.168.50.1 as the Internet gateway and gateway to other local IP subnets. Any
wireless computers or devices connecting to the 2.4GHz wireless SSID will also obtain
192.168.50.x/255.255.255.0 address settings while connecting to 5GHz1 or 5GHz2 SSIDs
will remain on the LAN network. Additional VLANs can be created on the router and
switch in which 802.1Q VLAN traffic can pass through the same single 802.1Q VLAN
tag/trunk link. Multiple SSIDs will appear in this section when enabled and configured.
Guest network SSID does not apply.
TEW-829DRU
24