Virtual Lans (Vlans); Create A Port-Based Vlan - TRENDnet TEW-829DRU User Manual

TRENDnet User's Guide

Virtual LANs (VLANs)

Network > VLAN
Your router supports port-based 802.1Q VLANs as well inter-VLAN routing. VLANs can
be assigned different IP address interfaces in which the router can route be between
VLAN IP subnets.

Create a port-based VLAN

1. Log into your router management page (see
on page 8).
2. Click on Network and click VLAN.
3. Before assigning which untagged and tagged VLAN member ports are assigned to a
new VLAN, the ports must be set to Off in the default VLAN VID: 1 (LAN). Also, click
the Inter VLAN Routing drop-down list and select Enabled to enable communication
between the LAN and other VLAN interfaces. Click Apply to save and commit the
changes. Example: We will remove ports 5-8 from the default VLAN VID: 1 (LAN)
interface so these ports can be re-assigned as untagged member ports of new VLANs
in example below.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your router management page"
4. To create a new 802.1Q VLAN, under the VLANs section, click Add.
5. Under VID, enter the VLAN ID to assign to the new VLAN (4-4094, VLAN IDs 1-3 are
reserved for use with the default LAN, WAN1, WAN2 interfaces) and set the untagged
VLAN member ports. Example: In the example below, we will create a new VLAN with
VLAN ID: 50 and assign ports 5 & 6 as untagged member ports.
6. Enter the VLAN IP interface configuration under IP Address and Subnet Mask.
Example: In the example below, we will enter the VLAN 50 interface IP address as
192.168.50.1 and subnet mask 255.255.255.0.
TEW-829DRU
19