TRENDnet TEW-829DRU User Manual page 7

TRENDnet User's Guide
LED Indicators
LED Description
Solid Blue – Device is receiving power and turned on.
Off – Device is not receiving power or turned off.
Solid Blue – WPS connection process was successful. WPS
LED will remain on after successful connection for 2 minutes.
Blinking Blue – WPS is activated and setup process has
started. Within 2 minutes, start the WPS process on your
WPS client device to connect.
Off – WPS setup process has stopped or has not been
activated.
Solid Blue – 2.4GHz (2-stream) wireless radio is turned on.
Blinking Blue – Data transmission on 2.4GHz radio.
Off – 2.4GHz (2-stream) wireless radio turned off.
Solid Blue – 5GHz
Blinking Blue – Data transmission on 5GHz
1
Off – 5GHz (4-stream) wireless radio turned off.
Solid Blue – 5GHz
Blinking Blue – Data transmission on 5GHz
2
Off – 5GHz (2-stream) wireless radio turned off.
LAN 1-8, WAN1 & WAN2 Ports
Port LEDs
LED (Right Side)
Solid Green – Port is connected at 1Gbps link speed.
Off – Port is connected at 10Mbps or 100Mbps link speed.
LED (Left Side)
Blinking Green - Data activity/transmission on port.
© Copyright 2018 TRENDnet. All Rights Reserved.
1
(4-stream) wireless radio is turned on.
1
radio.
2
(2-stream) wireless radio is turned on.
2
radio.
Port/Button Description
Ports/Buttons Description
Grounding Point Allows the device chassis to be connected to a known ground
point for electrical safety and protection possible shock or
surge during device operation and handling. (Grounding wire
and screw not included.)
Security Slot Allows for an optional cable lock attachment to secure the
device to a physical location.
RJ-45 Console Using the included RJ-45 to RS-232 console cable, this
Port interface provides console/terminal (command line interface)
access to the device for management and troubleshooting
purposes.
Terminal Settings:
Baud: 115200 / Data: 8 / Stop: 1 / Parity: None / Flow: None
USB 3.0 Port Allows for an optional USB storage device (flash drive,
external HDD, etc.) to be connected and used as a network
share through the Samba protocol. (FAT32/NTFS format only)
LAN Interface Connect network devices to the LAN interface ports 1-8 at
Ports 1-8 Gigabit, 10Mbps/100Mbps Full/Half Duplex. By default,
management access to the GUI and command line interface
via default LAN IP address: 192.168.10.1 / 255.255.255.0
WAN1 Interface Connects to your Internet Service Provider (ISP) equipment
Port for Internet connectivity such as modem. By default, WAN
mode is set for failover and WAN1 is configured as the
primary WAN link for Internet connectivity.
WAN2 Interface Connects to your Internet Service Provider (ISP) equipment
Port for Internet connectivity such as modem. By default, WAN
mode is set for failover and WAN2 is configured as the
secondary WAN link for Internet connectivity.
Reset Button Resets device to factory defaults. Using a paperclip, push and
hold the reset button for 15 seconds and release to reset the
device to factory defaults.
Power Port Connects the included power adapter to supply device
power.
On(-)/Off(o) Turns the device power On(-) or Off(o).
Power Switch
TEW-829DRU
4