Fcc Rules; Part 15; Part 68 - Bosch D9412G Operations & Installation Manual

D9412G/D7412G | Operation & Installation Guide |
1.4

FCC Rules

1.4. 1

Part 15

This equipment was tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15
of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy; and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference, in which case the
user is required to correct the interference at his/her
own expense.
1.4.2

Part 68

This equipment complies with Part 68 of FCC rules. A
label contains, among other information, the FCC
registration number and ringer equivalence number
(REN). If requested, this information must be provided
to the telephone company.
The Bosch Security Systems D9412G/D7412G Control
Panels are registered for connection to the public
telephone network using an RJ38X or RJ31X jack.
The REN is used to determine the number of devices
that can be connected to the telephone line. Excessive
RENs on the telephone line may result in the devices
not ringing in response to an incoming call. In most, but
not all areas, the sum of the RENs should not exceed
five. To be certain of the number of devices that may be
connected to the line, as determined by the RENs,
contact the telephone company to determine the
maximum REN for the calling area.
Bosch Security Systems | 10/03 | 43488E
1.0 Introduction
If trouble is experienced with the D9412G/D7412G
Control Panels, please contact Bosch Security Systems
Customer Service for repair and/or warranty
information. If the trouble is causing harm to the
telephone network, the telephone company may request
that the equipment be removed from the network until
the problem is resolved. User repairs must not be made,
and doing so will void the user's warranty.
If the D9412G/D7412G Control Panels cause harm to
the telephone network, the telephone company will
attempt to notify you in advance. If advance notice is
not practical, the telephone company will notify you as
soon as possible. Also, you will be advised of your right
to file a complaint with the FCC if you believe it is
necessary.
The telephone company may make changes in its
facilities, equipment, operations, or procedures that
could affect the operation of the equipment. If this
happens, the telephone company will provide advance
notice in order for the necessary modifications to be
made in order to maintain uninterrupted service.
This equipment cannot be used on public coin service
provided by the telephone company. Connection to
Party Line service is subject to state tariffs. (Contact
your state public utilities commission for information.)
FCC Registration Number: AJ9MUL-46532-AL-E
Service Center in USA: National Repair Center
Ringer Equivalence: 0.1B
130 Perinton Parkway
Fairport, NY 14450
(585) 223-4220
EN | 9