Table of Contents
Advertisement
1.0
Notices
1.1
General Notices
These instructions contain procedures to follow in order to avoid personal injury and/or damage to the equipment.
NFPA 72 requires a complete system-wide functional test be performed following any modifications, repair,
upgrades or adjustments made to the system's components, hardware, wiring, programming and software/
firmware.
The material and instructions covered in this operator's guide have been carefully checked for accuracy and are presumed
to be reliable. However, the manufacturer assumes no responsibility for inaccuracies and reserves the right to modify
and revise this installation guide without notice.
This manual covers the operation of the D8024 Analog Fire Alarm Control Panel (FACP). See the D8024 Installation
Guide (P/N: 35394) for instructions on the installation of the D8024.
1.2
FCC Notice
1.2.1
Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial
installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user is encouraged to try to
correct the interference by one or more of the following measures:
1)
Reorient or relocate the receiving antenna.
2)
Increase the separation between the equipment and the receiver.
3)
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4)
Consult the dealer or an experienced radio/TV technician for help.
1.3
UL/NFPA Notice
Radionics' D8024 Analog Fire Alarm Control Panel is UL Listed for NFPA 72, Central Station and Remote Station.
All references to NFPA and related requirements are based upon compliance with the 1993 edition of NFPA 72, National
Fire Alarm Code. Since installation specifications are nearly always based upon a specific edition of a standard which
has been legally adopted by the Authority Having Jurisdiction (AHJ), earlier editions of NFPA standards will generally
apply. Consult with the appropriate AHJ for confirmation.
Copyright © 2001 Radionics
D8024 Operator's Guide
National Security Systems (800)457-1999
http://www.nationalsecuritysystems.com
Page 5
D8024
Notices
35394D
Advertisement
Table of Contents
