Installing The Control Panel; Connecting Earth Ground; Terminal 10 - Bosch D9412GV3 Installation Instructions Manual

Control Panels
Figure 1.1 Enclosure Mounting
Callout Description
1 Point chart label
2 Mounting skirt hooks (2)
3 Module mounting holes (12)
4 Tamper switch mounting holes (5)
5 Skirt mounting hole (1)
6 Enclosure mounting holes (5)
7 Mounting skirt hook holes (2)
8 Back of the control panel
9 Lock down tab
1.4

Installing the Control Panel

1.
2.
3.
1.5

Connecting Earth Ground

1.5.1

Terminal 10

To help prevent damage from electrostatic charges or other transient electrical surges,
connect the system to earth ground at Terminal 10 before making other connections.
Recommended earth ground references are a grounding rod or a cold water pipe.
Bosch Security Systems, Inc.
Place the control panel over the inside back of the enclosure, aligning the large
rectangular openings of the mounting skirt with the mounting hooks of the enclosure.
Slide the control panel down so that it hangs on the hooks. Refer to Figure 1.1, Page 5.
Remove the tape from the #6 x 1/4-in. screw in the mounting tab on the control panel.
The screw passes through the mounting tab and into the skirt mounting hole in the
enclosure. Tighten the screw to secure the control panel in the enclosure.
Connect earth ground to the control panel before making any other connections. Refer to
Section 1.5 Connecting Earth Ground, page 5.
UL Installation Instructions
Installation | en 5
F.01U.167.105 | 02 | 2010.11